CAD Engineering Design Blog

In the first place, the prototype looked completely flawless! On the other hand, the 3D models were clean and the assemblies fit perfectly...

Well, it was just a pad! That too just a single one! So, the board looked fine and the design passed the initial DRC. Also, the prototype...

Clearly, switching ECAD tools shouldn’t feel like a massive challenge. But too often, it does. Apparently, for engineers migrating...

So, whenever engineers think of failure in automotive electronics, they ponder upon weak components or bad solder joints. But do you...

So, you may ask this to any automotive electronics engineer about what they fear the most, and high-chances are that you will hear...

It goes without saying that FMEA is supposed to prevent failure at any cost! But what if the failure starts where most people aren’t...